Draft Stopping & Fireblocking in Franklin, MA

Franklin, MA · Norfolk County

Draft Stopping & Fireblocking in Franklin, MA

Fireblocking and draft stopping in Franklin, MA: life-safety work that also cuts drafts and heat loss.

Built for Franklin

Draft stopping and fireblocking for Franklin builders

Every wire, pipe and duct that passes through a top plate or floor is a gap. We seal those penetrations with fire-rated foam, sealant or mineral wool, which also stops air leaks.

When older buildings are renovated, open balloon-frame walls often need new fireblocking at each floor line before inspection.

Franklin is about 18 miles from our Westborough, MA headquarters, and our crews work across Norfolk County every week.

  • Inspection-ready work
  • Meets building code requirements
  • Works for homes and commercial buildings
  • Scheduled around other trades
Fireblocking at a stair stringer

Applications

Where code calls for fireblocking in Franklin

We seal every location the code and the inspector look for.

Blocking installed in balloon-framed walls

Balloon-framed walls

Open stud bays in older homes are blocked at each floor.
Fire-rated caulk sealing holes in a wood top plate

Top and bottom plates

Wire and pipe holes through plates are sealed with fire-rated foam.
Fire-rated sealant around pipes at a top plate

Pipe and wire penetrations

Every penetration through a rated assembly gets sealed.

Local homes

Know your Franklin home

Franklin has older homes around its historic downtown and many newer subdivisions built from the 1980s through the 2000s.

Franklin's homes spread from its historic downtown and Dean College to newer neighborhoods along I-495 and Route 140, with Unionville and Franklin State Forest on the edges of town. Many homes built since the 1980s have bonus rooms over garages that run cold in winter and hot in summer.

Norfolk County stretches from coastal cities like Quincy to suburbs along I-95 and I-495, with housing that ranges from historic homes to newer subdivisions.

Franklin at a glance

Region
the I-495 corridor
County
Norfolk County
Climate zone
5A
From our Westborough office
About 18 miles
Efficiency program
Mass Save®
Massachusetts street with colonial and cape homes in the fall

Recommended plan

How we would fireblock a typical older home in Franklin

Step 1

Block the stud bays

Balloon-framed walls are blocked at each floor during renovations.

Step 2

Seal around chimneys

Gaps around masonry get non-combustible materials.

Step 3

Close old chases

Abandoned flues and chases are sealed.

Step 4

Tighten the house

The same work stops drafts between floors.

New construction needs fireblocking at penetrations, soffits and floor lines before the insulation inspection, and we schedule around your framing crew.

Climate, code & rebates

Insulation targets and incentives in Franklin

Fire-rated foam sealing wires through a top plate

Climate & code

Climate zone 5A targets

Franklin is in IECC climate zone 5A. For attics in zones 5 and 6, ENERGY STAR recommends R-49 to R-60, and many existing homes here have far less. New construction and major renovations in Massachusetts follow the state energy code, and many towns have adopted the stricter Stretch or Specialized codes.

Fire caulk around electrical cables

Incentives

Mass Save® in Massachusetts

Massachusetts homeowners can start with a no-cost Mass Save® Home Energy Assessment, which can lead to incentives for insulation and air sealing. As a Mass Save® partner, BCI Group helps you through the program steps.

About Mass Save® →

How it works

From rough-in to inspection in Franklin

  1. 01

    Schedule

    We book the work right after electrical and plumbing rough-in.

  2. 02

    Install

    Fire-rated foam, sealant and blocking go in where required.

  3. 03

    Check

    We walk every floor to confirm nothing was missed.

  4. 04

    Hand-off

    Your insulation crew can start right after.

Pricing

Pricing fireblocking in Franklin

Every building is different, so we price each project after reviewing plans or the framing. Your quote lists the work clearly.

  • Materials required by location
  • Bundling with insulation
  • Building size and number of floors
  • Documentation for inspection
  • Access after rough-in
Inspector checking fireblocking

Our work

Our fireblocking work near Franklin

FAQ

Fireblocking questions in Franklin, MA

When should fireblocking be done?

After electrical, plumbing and HVAC rough-in, and before insulation and drywall.

What materials do you use?

Approved fire-rated foam and sealants, mineral wool and lumber or gypsum, depending on the location.

Do you work with builders?

Yes. We quote from plans and schedule around your inspections.

Do you document the work?

Yes. We can share photos and notes for your inspector and records.

Is fireblocking required in Franklin?

Building codes require fireblocking in concealed spaces in new construction and many renovations. Your local building department enforces it at inspection.

Is regular spray foam fireblocking?

Only foams approved for fireblocking can be used, and only where the code allows them.

How soon can you start a fireblocking project in Franklin?

Our crews travel about 18 miles from Westborough, MA to Franklin, and we group estimates and jobs by area. You'll get a start date with your written quote.

Do you also work in towns near Franklin?

Yes. Besides Franklin, we serve nearby communities such as Milford, Holliston and Upton, along with the rest of Norfolk County.

Free estimate · No commitment

Stop overpaying for energy.

Fill out the form or reach us directly — we respond within one business day.

Free, no-obligation estimate
Mass Save® rebates handled end-to-end
Licensed & insured contractors
Engineering-grade energy assessments
Serving MA · NH · RI · CT · ME

10+ Years

Serving New England

HERS Certified

In-house ratings

Mass Save®

Rebates handled

5 States

MA · NH · RI · CT · ME